Automotive Heat Exchanger

We don't have to make outrageous

claims about our heat exchangers,

because......well, everyone knows they're the best.

Don't be fooled by imitations. 

The automotive grade heat exchanger with 1/2" barbed fittings on both the inlet and outlet fresh water ports. Simply radiator clamp 1/2" hose in and out for ease of use.  For compatibility and ease of use, the engine coolant side is 5/8" barb which is the most common heater hose size. This allows the heat exchanger to be placed in line or hidden so that the outlet of the fresh water delivery hose can be run straight to a shower, sink, or to an external shower connector fitting at the front or rear of a vehicle.

The Glind heat exchanger as it sits on the mount bracket, measures 355 mm long and is 105 mm high. Remember to add a little on each end to accommodate for hoses. The beauty of this heat exchanger is that it can be mounted horizontally or vertically so fitting becomes simpler. If you need a tight hose bend on the ends, use the pre-moulded heater hose, also available from Glind.

The Glind heat exchangers are sealed units, so the brass fittings CANNOT be changed or altered.

 Comes with the standard mount plate, spacers, nuts and bolts, so it is ready to fit. 

See fitting instructions for use with hot and cold taps by using only 1 pressure pump.